Vspec connect error
Posted: Tue Oct 17, 2017 2:19 pm
Hi,
I use Vspec (v 4.26)to check my telluric calibration before submitting spectra. Lately when I select my spectrum I have been getting a "Connect error" message when click on the icon for this telluric check. This error message appears 3 or4 times, the results are shown on my spectrum, but there are no comparison spectrum that usually come up. Also the image's header appears which has not happened before. Is anyone else experiencing this or does anyone know of a solution? I have tried going back to earlier versions but get the same results.
Thanks,
Keith Graham
I use Vspec (v 4.26)to check my telluric calibration before submitting spectra. Lately when I select my spectrum I have been getting a "Connect error" message when click on the icon for this telluric check. This error message appears 3 or4 times, the results are shown on my spectrum, but there are no comparison spectrum that usually come up. Also the image's header appears which has not happened before. Is anyone else experiencing this or does anyone know of a solution? I have tried going back to earlier versions but get the same results.
Thanks,
Keith Graham