Hi,
I have a LISA and my camera is an old reliable QSI520i and I ahve followed as good as possible al installation steps according to the user manual.
One thing bothers me a bit. According to the calculation the Neon emission Line should be in the position pixel 1167 but after hurs of trying to get it there I was able to leave it at pixel 1172. Does that matter ? Just by tightening the locking screws it moves ... I think I will develop a stepper motor adjustment for the lever
Thanks for any tip
regards Rainer
Lisa with QSI520i
-
- Posts: 135
- Joined: Thu Sep 29, 2011 9:36 pm
Lisa with QSI520i
regards Rainer____Observatorio Real de 14_____MÉXICO_____N 22° W 101°
-
- Posts: 161
- Joined: Wed Dec 11, 2013 5:50 pm
Re: Lisa with QSI520i
Hi Rainer,
That is close enough. Don't worry about it.
It is a very frustrating adjustment to make on the LISA. You did well to get that close!
Best wishes,
David
That is close enough. Don't worry about it.
It is a very frustrating adjustment to make on the LISA. You did well to get that close!
Best wishes,
David
-
- Posts: 135
- Joined: Thu Sep 29, 2011 9:36 pm
Re: Lisa with QSI520i
Hi David,
Thanks. I will not touch it again and now focus on getting good calibrations testing different ways.
regards Rainer
Thanks. I will not touch it again and now focus on getting good calibrations testing different ways.
regards Rainer
regards Rainer____Observatorio Real de 14_____MÉXICO_____N 22° W 101°