Page 1 of 1

Lisa with QSI520i

PostPosted: Tue Aug 02, 2022 11:37 pm
by Rainer Ehlert
Hi,

I have a LISA and my camera is an old reliable QSI520i and I ahve followed as good as possible al installation steps according to the user manual.

One thing bothers me a bit. According to the calculation the Neon emission Line should be in the position pixel 1167 but after hurs of trying to get it there I was able to leave it at pixel 1172. Does that matter ? Just by tightening the locking screws it moves ... I think I will develop a stepper motor adjustment for the lever :roll:

Thanks for any tip

regards Rainer


Neon_6598_Pixel_1172_not_Pixel_1167.jpg

Re: Lisa with QSI520i

PostPosted: Wed Aug 03, 2022 8:04 am
by David Boyd
Hi Rainer,

That is close enough. Don't worry about it.

It is a very frustrating adjustment to make on the LISA. You did well to get that close!

Best wishes,
David

Re: Lisa with QSI520i

PostPosted: Wed Aug 03, 2022 3:44 pm
by Rainer Ehlert
Hi David,

Thanks. I will not touch it again ;) and now focus on getting good calibrations testing different ways.

regards Rainer