Alpy600 calibration module remote operation
Posted: Sun Dec 21, 2014 11:28 am
Finally, I've made possible to operate Alpy600 calibration module remotely from my computer, using the same controller module I am using to operate a focuser motor, as I told in another topic:
http://www.spectro-aras.com/forum/viewt ... =866#p3918
Link to controller and cable manufacturer/seller:
http://www.lunatico.es
http://tienda.lunatico.es
Seletek module has to output ports. On the first is attached cable to focuser motor. At the second port (EXP) is attached a two way connector which attaches to Alpy calibr. module connectors. At computer, from a program named pinbypin, I can switch ON and OFF pins number 2 and 3. Pin #2 is connected to flat lamp, and #3 is connected to neon lamp.
http://www.spectro-aras.com/forum/viewt ... =866#p3918
Link to controller and cable manufacturer/seller:
http://www.lunatico.es
http://tienda.lunatico.es
Seletek module has to output ports. On the first is attached cable to focuser motor. At the second port (EXP) is attached a two way connector which attaches to Alpy calibr. module connectors. At computer, from a program named pinbypin, I can switch ON and OFF pins number 2 and 3. Pin #2 is connected to flat lamp, and #3 is connected to neon lamp.